Dust is a turntable’s discreet enemy: it settles on the platter, works its way around the spindle, and eventually interferes with the mechanics. This rigid acrylic dust cover encloses the RP-1000, RP-2000, RP-4000, or RP5000MK4 in a durable shell that protects against dirt and scratches between sessions. It can be attached with hinges or simply placed on top, depending on your setup.
The acrylic used for this dust cover remains firm and retains its shape over the years. Where a soft cover sags, this shell keeps its lines and absorbs minor impacts without denting or cracking. It keeps dust at bay, protects the platter and tonearm from scratches, and limits wear caused by a mixing environment, where equipment is subject to repeated handling.
The dust cover measures 43.5 cm wide, 34 cm deep, and 6.4 cm high. A peripheral edge follows the turntable chassis and keeps the shell in place, with no gaps that would allow dust to enter from the sides.
A set of hinges is supplied with the dust cover. Attached at the rear, they connect the shell to the chassis: simply lift it to access the platter, then lower it again when the turntable is at rest. Installation takes just a few minutes, and the mounting points match those of the RP series.
There is no need to screw on the hinges. The shell can also be placed freely and removed in one motion before mixing, preventing any contact during playback. Both uses work with the same part; the choice is yours depending on the available space and how you work.
The dust cover fits all versions of the RP-1000, RP-2000, RP-4000, and RP5000MK4, regardless of version (MK1, MK2, MK3, or M3D). On these direct-drive turntables, dust does more than just dirty the surface. When it accumulates around the spindle and beneath the platter, it can slow rotation and affect torque. Keeping the mechanism protected helps preserve its consistency.
Its standard dimensions allow it to fit other conventionally sized turntables, provided their measurements are checked beforehand. The outline remains the same; only the hinge position may sometimes require adjustment.
The dust cover protects the turntable when it is not in use. To play a record, lift it on its hinges or remove it to clear the platter and tonearm. Its purpose is protection when idle, not covering the turntable during playback.
No. On the RP-1000, RP-2000, RP-4000 and RP5000MK4, the screw mounting points are provided and aligned with the supplied hinges. Drilling is only required for turntables of other sizes with different mounting points.
That is not its role. It protects against dust and impacts, but does not affect resonance or feedback. To isolate a turntable from vibrations, you need to look at the stand and damping feet.
Yes, as long as they remain underneath. In the closed position, the cover protects the tonearm, cartridge and stylus from impacts and dust which, when deposited on a stylus, degrades playback and wears out the groove more quickly.
It does not replace a transport case. Secured on hinges, it is suitable for occasional sheltered transport, but for regular touring trips, a flight case remains the appropriate solution for this type of equipment.
Philippe
Very nice cover, the material does not feel like cheap plastic, very high quality.
Comment from 20 July 2026 — Experience from 9 July 2026
Roberto
Elegant product, excellent, quick to assemble and outstandingly functional.
Comment from 20 January 2026 — Experience from 9 January 2026
Philippe
Superb dust cover installed on a Luxman PD264 turntable, by making additional holes in the turntable’s base, but it fits very well. I’m only giving 4 stars because there’s a very small scratch on the top, which I noticed while installing the cover, but it’s invisible once in place.
Comment from 30 June 2025 — Experience from 30 May 2025
