Suspended from the ceiling like a light fixture, the Planet L sphere leaves the furniture behind and frees up the space occupied by its tabletop base. Elipson has designed a 300 mm diameter brushed steel ring for it, held by three steel cables, into which the speaker fits. The drop can be adjusted to up to 5 m below the ceiling: the speaker can be brought down to listening height in a tall room or kept just below a standard ceiling.
A ring and three cables to support the sphere
The principle follows that of the tabletop stand supplied with the Planet L. The 290 mm sphere rests in a ring barely wider than itself, and this ring is suspended by three steel cables spaced around its circumference. Three attachment points provide stable support, without the swaying that a single-cable suspension would produce. The brushed steel finish matches the other accessories in the range, including the Planet L wall mount. The assembly weighs approximately 1.6 kg and comes in flat packaging measuring 310 × 310 × 40 mm.
Visually, the ring remains slim and leaves all the attention to the sphere and its colour. Once in place, the speaker looks more like a living room pendant light than a hi-fi component, and that is precisely the design intent of this accessory.
Adjusting the height and aiming towards the listening position
The cables can be adjusted to the desired length, up to 5 m. In the Planet L manual, Elipson recommends placing the speaker at head height or higher: the suspension follows this recommendation without a stand or furniture. The sphere can swivel in the ring, allowing the driver to be turned towards the sofa or table rather than the floor. This adjustment matters on the Planet L, which uses a coaxial driver: the tweeter is positioned at the centre of the mid/bass driver, so the entire frequency range comes from a single point, and it is this point that is aimed towards the listener.
The suspended speaker sits away from the walls and floor. Bass gains clarity, as nearby reflections that often thicken the lower frequencies disappear, but it also loses the reinforcement provided by a wall directly behind it. Depending on the room and personal taste, the bass will therefore sound a little lighter than with a speaker placed on a shelf against a wall.
Compatible with Planet L, Planet L Performance and Planet LW
The mount accommodates all the 290 mm spheres in the family. The Planet L Performance, which succeeded the Planet L, retains exactly the same diameter and 7 kg weight; it can be suspended in the same way, as can the Gold Edition. The Planet LW, the older active wireless version, also shares the same enclosure. As it has built-in amplification, it requires a mains cable running to the speaker, which needs to be planned for during installation.
Models outside this size are not covered: the smaller Planet M has its own mounts.
Preparing for ceiling installation
Once the speaker is in place, the anchor point carries a little over 8.5 kg. Wall plugs and screws should be chosen according to the ceiling material: a concrete ceiling or wooden joist provides a direct fixing point, while plasterboard requires fixings suitable for a suspended load. If there is any doubt about the structure, an installer or electrician will be able to check the mounting surface.
The speaker cable must reach the fixing point through the suspended ceiling or a conduit, then run down to the sphere’s terminals. It is best to measure this entire route, including the drop, before ordering the cable. As with any speaker, the amplifier must be switched off during connection.
In a home cinema, the suspension often solves the issue of rear speakers: behind a sofa positioned in the middle of the room, there is neither a wall nor furniture to place them on, and a stand gets in the way. In a living room where furniture space is limited, it allows a stereo pair to be installed without placing anything on the floor.