Van den Hul The Digi-Coupler, digital coaxial cable
Between a CD player, a television or a streamer and the converter that turns data into music, the coaxial connection carries a very fast digital signal, sensitive to impedance reflections as well as radio interference. Van den Hul addresses this with the most advanced cable in its S/PDIF range: a triaxial construction with multiple shields, impedance maintained within half an ohm, and a halogen-free jacket developed by the Dutch brand.
75-ohm impedance maintained into the gigahertz range
The coaxial S/PDIF standard relies on a 75-ohm impedance, and any deviation along the connection sends part of the signal back towards the source. These reflections distort the rising and falling edges of the data, blurring the precise instant when the converter’s receiver reads each bit: this is jitter, which Van den Hul aims to reduce by maintaining the impedance of the Digi-Coupler at 75 ohms ± 0.5 ohm up to 3 GHz. The cable claims wide bandwidth and low attenuation per metre, two parameters that naturally deteriorate as length increases.
The central oxygen-free copper (OFC) conductor, with a cross-sectional area of 0.283 mm², is insulated with foamed polyethylene. The air bubbles trapped in this foam lower the dielectric constant of the insulation and limit losses at high frequencies. This geometry remains stable only if the cable is not bent too tightly: Van den Hul specifies a minimum bend radius of 8 cm to maintain constant impedance, which requires a little space behind the equipment.
Three braids and three foils against interference
A triaxial cable is a coaxial cable surrounded by an additional, separately insulated shield. The Digi-Coupler takes this principle quite far, alternating three aluminium foils with three dense braids of 128, 128 and then 192 strands of OFC copper coated with high-density silver, all wrapped in a carbon-saturated layer that the brand calls Linear Structured Carbon. Van den Hul classifies this cable among its “superscreened” models, with very low transfer impedance: an interference current flowing on the outer surface induces virtually no voltage inside, where the signal travels.
This protection works both ways. The signal remains shielded from interference from Wi-Fi, phones or switching power supplies, and the cable itself radiates very little towards neighbouring analogue connections. Van den Hul also recommends always keeping digital and analogue cables separate in a system. The low resistance of the intermediate conductor (0.814 Ω per 100 m) and the outer shield (0.747 Ω per 100 m) provides a very low-resistance path for the return current. The brand highlights this immunity for long connections, up to the distances found in a recording studio.
A Hulliflex jacket free of halogens and plasticisers
The gold-coloured outer jacket is made of Hulliflex, a polymer developed by Van den Hul that contains neither halogens nor plasticisers. Without plasticisers, the material does not harden or crack over the years; it protects the silver-coated braids from air laden with corrosive compounds, preserving their conductivity over time. In the event of a fire, the absence of halogens prevents the release of acidic gases. The intermediate conductor is insulated with polyethylene, and the jacket withstands a voltage of at least 300 V RMS.
The 8.2 mm outer diameter makes for a fairly stiff cable. It puts more weight on RCA sockets than a thin cable and does not tolerate being pressed against a wall or the back of a cabinet well, so it is worth planning its routing before positioning the equipment.
Gold-plated plugs and possible connections
The gold-plated RCA plugs connect any coaxial S/PDIF output to an input of the same type: CD transport to converter, television to amplifier, streamer or server to an external DAC. Van den Hul states that the Digi-Coupler also carries video and high-frequency signals, since its impedance and shielding properties apply to any 75-ohm connection.
What the cable can improve is the signal’s timing integrity and the noise picked up, not the nature of the data, which reaches the receiver unchanged in any case. The audible difference therefore depends greatly on the converter: a receiver stage equipped with an effective phase-locked loop or internal reclocking already rejects a good deal of jitter, whereas a simpler receiver remains sensitive to it. Within the Van den Hul range, the Digi-Coupler is a technically enhanced version of The Triaxial Professional 75 Ohm cable.